Archive for February 8th, 2018

Centrifugal Pumps Can Create Vacuums

Thursday, February 8th, 2018

    Last time we performed an engineering experiment that demonstrated how we can lower the boiling point of water inside a lidded pot without applying heat if we use a vacuum pump to lower the pot’s internal pressure.   We discovered that when pressure was lowered to 0.25 pounds per square inch (PSI), the water inside the pot turned to steam at a mere 59ºF, which initiated the cavitation process.   Today we’ll see how centrifugal pumps can also create vacuums to initiate cavitation.


Centrifugal Pumps Can Create Vacuums

Centrifugal Pumps Can Create Vacuums


    As we learned in a past blog, centrifugal pumps contain rotating impellers within a housing called a volute.   This housing has an inlet, known as an eye, where water flows into the pump from a pipe, and an outlet, known as a discharge, where water flows out of the pump.   The centrifugal pump creates a vacuum by mimicking the action of sucking soda through a straw.    The spinning impeller draws water into the housing by creating low pressure at the inlet, and if the pressure gets low enough, we’ll recreate what happened in our vacuum pump and pot experiment.   Water will boil at temps far lower than normal boiling point of 212 ºF.   Just as in our experiment, if pressure is lowered to 0.23 PSI, water present at the pump inlet will boil at 59ºF, causing thousands of tiny steam bubbles to form and the pump to cavitate.

    They’re just tiny bubbles, so what harm can they do? We’ll find out next time.

opyright 2018 – Philip J. O’Keefe, PE

Engineering Expert Witness Blog