How A Power Plant Condenser Works, Part 3

      We’ve been discussing various aspects of a power plant’s water-to-steam cycle, from machinery specifics to identifying inefficiencies, and today we’ll do more of the same by introducing the condenser hot well and discussing its importance as a key contributor to the conservation of energy, specifically heat energy.   Let’s start by returning our attention to the steam inside the condenser vessel.

      Last week we traced the path of the condenser’s tubes and learned that the cool water contained within them serve to regulate the steam’s temperature surrounding them so that temperatures don’t rise dangerously high.   To fully understand the important result of this dynamic we have to revisit the concept of latent heat energy explored in a previous article.   More specifically, how this energy factors into the transformation of water into steam and vice versa.

      Steam entering the condenser from the steam turbine contains latent heat energy that was added earlier in the water/steam cycle by the boiler.   This steam enters the condenser just above the boiling point of water, and it will give up all of its latent heat energy due to its attraction to the cool water inside the condenser tubes.   This initiates the process of condensation, and water droplets form on the exterior surfaces of the tubes.

Power Plant Condenser

      The water droplets fall like rain from the tube surfaces into the hot well situated at the bottom of the condenser.   This hot well is essentially a large basin that serves as a collection point for the condensed water, otherwise known as condensate.

      It’s important to collect the condensate in the hot well and not just empty it back into the lake, because condensate is water that has already undergone the process of purification.   It’s been made to pass through a water treatment plant prior to being put to use in the boiler, and that purified water took both time and energy to create.   The purified condensate also contains a lot of sensible heat energy which was added by the boiler to raise the water temperature to boiling point, as we learned in another previous article.   This heat energy was produced by the burning of expensive fuels, such as coal, oil, or natural gas.

      So it’s clear that the condensate collecting in the hot well has already had a lot of energy put into it, energy we don’t want to lose, and that’s why its an integral part of the water-to-steam setup.   It acts as a reservoir, and the drain in its bottom allows the condensate to flow from the condenser, then follow a path to the boiler, where it will be recycled and put to renewed use within the power plant.

      Next week we’ll follow that path to see how the condensate’s residual heat energy is put to good use.


Tags: , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,

Comments are closed.